Da-Lite ViewShare, Инструкция

Страница: 16 / 20

16
1. Locate the wall switch and remove the cover plate from the wall
switch and remove the switch from the junction box.
2. Locate the two tactile buttons on the back of the switch. They
are black round buttons on silver plates.
3. To adjust the down limit switch, press and hold the down tactile
button until the LED on the back of the switch turns solid red. This
will put the motor in limit set mode. Turn the wall switch over and
use the down button on the front of the switch. Press and hold
the down button until the desired down position is reached. If you
travel too far down, press the up button to move the screen
upward. If you press and let go of either the up or down buttons,
the motor will do a small jog in that direction for fine adjustment
of the screen. Once the desired position is reached, turn the
switch over; press and hold the down tactile button until the LED
on back of switch blinks red twice. The down limit is now set.
CAUTION: Do not adjust for more drop than what was
ordered. At least 1–1/2 wraps of fabric must remain on the
roller. This screen comes standard with 12" black at the top.
NOTE:
If the screen is in limit set mode and no buttons are
pushed for 20 seconds, the LED on the back of the wall switch
will turn off, the motor will return to run mode and no changes
will be saved. If this occurs, return to step 3 for down limit
adjustment or step 4 for up limit adjustment.
4. To adjust the up limit switch, press and hold the up tactile button
until the LED on the back of the switch turns solid green. This will
put the motor in limit set mode. Turn the wall switch over and
use the up button on the front of the switch. Press and hold the
up button until the desired up position is reached. If you travel
too far up, press the down button to move the screen downward.
If you press and let go of either the up or down buttons, the
motor will do a small jog in that direction for fine adjustment of
the screen. Once the desired position is reached, turn the switch
over; press and hold the up tactile button until the LED on back
of switch blinks green twice. The up limit is now set.
CAUTION: Adjusting the limits by more than 6” can cause the
screen surface to lose proper tensioning.
5. To test the limit switch settings, press and release the up or down
buttons on the switch to operate the screen.
6. Replace the switch and cover plate on the wall.
IMPORTANT NOTE:
The wall switch is REQUIRED to make any
limit switch adjustments, even if a third party control system is
used. Therefore, it is advised to wire the switch or provide a
3-conductor connection that is accessible.
Appendix A: Screen Adjustment for Type 3 Motor (LS suffix in Part Number)
TYPE 3 MOTOR
No manual limit adjustments
on end of motor
RJ-45 cable
3-wire connection
TYPE 3 WALL SWITCH
Bus
Down Limit
Tactile Button
Up Limit
Tactile Button
Back of Wall Switch
5V COM BUS