Da-Lite Designer Da-Tab Electrol, Инструкция

Страница: 4 / 8

4
Designer Da-Tab Electrol
®
Installation
1. Hang screen from wall or ceiling.
For Wall Mounting
Hardware Provided
2 – “V” Bars ( one is factory mounted to the back
of the case; one will be mounted to the wall)
6 – Toggle Bolts, 4"
6 – Lead Shields, #10-14 x 1-1⁄ 2"
6 – Phillips Flat Head Wood Screws, #10 x 2"
Tools Required
Electric Drill
Masonry Bit 5⁄ 16" (if mounting in solid masonry
or concrete)
Screw Driver, #2 Flat Tip (if using toggle bolts) or
#2 Phillips (if mounting in solid masonry or concrete)
Determine the height of the top of the case from the
floor. This will be the height of the wall mounted “V” bar.
Hold the loose “V” bar to the wall at the height
determined above (MAKE SURE IT IS LEVEL), and mark
the location for the screw holes. To mount the “V” bar on
solid concrete or masonry wall, drill 5⁄ 16" holes and insert
the lead shields. Fasten the “V” bar to the wall using the
#10 x 2" wood screws. If you are mounting to a hollow
wall, drill 1⁄ 2" holes and insert the toggle bolts. Then
fasten the “V” bar to the wall with the toggle bolts. Now
set the case in place on the wall with the “V” bar of the
case nestled into the “V” bar on the wall.
For Ceiling Mounting
Position and properly anchor screw hooks into ceiling, beam
or other solid surface. Then proceed to use the two “D” rings
that are factory mounted to the top of the case to hang the
case securely.
2. Install electrical hook-up that applies to your unit. Make
sure to review your electrical installation checklist and
wiring diagrams (included) for either 120 volt switch,
220/240 volt switch or low voltage control. See Figure 3.
3. Test installation by running screen up and down a few
times. Be prepared to stop screen. Standard Duty Cycle:
1 MIN. ON / 3 MIN. OFF.
NOTE: Must be installed in accordance with the requirements
of the Local Building Codes, the Canadian Electrical Code
(CEC), CAN/CSA C22.1 and the National Electric Code (NEC),
NFPA 70.
7"
7"
A = Fabric Width + 14"
B = Fabric Width
Picture
Surface
6"
5 1/2"
5 1/2"
A
B