Da-Lite Designer Da-Tab Electrol, Инструкция

Страница: 3 / 8

3
Before proceeding with the installation of the screen, please read the installation and operations instructions thoroughly!
CAUTION! Do not cut wrapping paper or tape with knife or any sharp tool. Remove by hand.
ATTENTION! Ne coupez pas le papier d'emballage ou le ruban adhésif avec un couteau ou un outil tranchant.
Retirez à la main.
1. Carefully unpack the screen and remove the outer wrapping.
2. Always handle screen in upright position.
3. Remove the front cover of the screen from the back of the
screen. Lift front cover up approximately 1/2" and pull away
from back of screen. See Figure 1.
4. Remove hex head screws that secure the metal shipping
brackets to the wood board.
5. Remove the Phillips head screws that attach the screen
case to the wood board.
6. Remove the metal shipping brackets from the back
of the slat.
7. There are two methods of mounting the screen, suspended
from ceiling and wall mounted. See Figure 2.
NOTE: Allow 1/2" above screen (when mounted) for front
cover of screen installation and removal.
8. Picture surface is centered in case. Case extends 7" beyond
surface on either end. Do not attach anything to screen slat
on the bottom of the screen.
Pre-Installation
Picture
Surface
Ceiling Mounting
Place “D” Rings
Over Hooks
Well Secured
In Ceiling.
Figure 1
Hanger Bracket
Hanger
Pin
Front
Cover
Back
Of
Screen
Picture
Surface
Slat
Picture
Surface
“V” Bar
Mounted
To The
Wall
Wall Mounting
Ceiling
Wall
“V” Bar
Mounted To
The Back Of
The Case At
The Factory
Figure 2
Allow A Minimum Of
1 1/4" From Ceiling