Pivoting Da-Lift
26P and 33P
Form E-453
Rev. 08 / 10
Caution:
This product is designed for ceiling
installation only. Qualified personnel using the appropriate
fasteners should mount the Pivoting Da-Lift. The surface
to which this unit is mounted must be capable of
supporting a static load of four times the combined weight
of the projector and mount. Do not attach to plaster or
drywall alone.
IMPORTANT SAFETY INSTRUCTIONS
When using your video equipment, basic safety
precautions should always be followed, including the
following:
1. Read and understand all instructions before
using.
2. Position the cord so that it will not be tripped
over, pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a
current rating at least equal to that of the
appliance should be used. Cords rated for less
amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not
disassemble this appliance. Contact an
authorized service dealer when repair work is
required. Incorrect reassembly can cause
electric shock when the appliance is used
subsequently.
5. The use of an accessory attachment not
recommended by the manufacturer may cause
a risk of fire, electric shock, or injury to
persons.
SAVE THESE INSTRUCTIONS
Required Tools:
-
7/16” wrench
-
1/2” wrench
-
9/16" wrench
-
Phillips screwdriver
IMPORTANT INSTALLATION NOTES
If installing this unit in “other space used
for environmental air”, it must be installed
with the plenum cover available from
Da-Lite Screen.
This unit must be installed in accordance
with the requirements of the Local Building
Codes, the Canadian Electrical Code
(CEC), CAN/CSA C22.1 and the National
Electrical Code (NEC), NFPA 70.
Suitable for Use in Other Environmental
Air Space in Accordance with Section
300.22(c) of the National Electrical Code,
and Sections 2-128, 12-010(3) and 12-100
of the Canadian Electrical Code, Part 1,
CSA C22.1.
