D-Teg Smarty BX1000, Руководство пользователя

Страница: 6 / 22

Drive Partner for your Safety
BX1000 / BX1000 Plus User Guide
www.d-teg.com
INSTALLATION INSTALLATION
Park your vehicle on a flat level surface.
Turn off the engine before installing the BX1000 / BX1000 Plus.
1. Insert the SD memory card into the SD card slot.
Please make sure to disconnect the power cable when
inserting or ejecting the SD memory card.
2. Attach the BX1000 / BX1000 Plus using the provided double
sided tape. The surface must be clean and dry before you
install. We recommended to install the product behind the
rear view mirror on the front windshield.
3. Adjust camera view. Make sure the lens has an unobstructed view.
Check from outside the vehicle to check the camera angle.
Arrange the power cord neatly alongside
the windshield and door pillar trim.
Use the provided wire splice clip as
seen in the picture on left.
4.BX1000 / BX1000 Plus unit requires a continuous 12-24V DC
power source from the vehicle. Plug in the power.
The provided power cord cable route should be from the left
side of the BX1000 / BX1000 Plus towards your power source.
NOTE
When the impact is light like a minor bump in the road, the G-sensor may
not recognize the impact and as a result it may not begin recording automatically.
Test and set your own G-sensor level for your vehicle.
NOTE Adhesive tape will not stick well with dust or oil, etc.
Warm temperatures are best (above 30 degrees centigrade ) when applying tape.