V019231_14_Rad-DX_Manual.docx
Page 5 of 19
2.2 Installation and Setup of your Rad-DX
2.2.1 Physical Installation
The Rad-DX is designed to be either wired and mounted into an electrical junction box or
attached to a wall in close proximity to an outlet.
2.2.1.1 Junction Box Method
Mounting a Rad-DX unit directly into a junction box requires the following steps:
Note:
An electrician should complete the installation to ensure the quality of the installation and
safety of the installer.
1.
Mount the Rad-DX wall bracket onto the junction box using the screws included. If a non-
standard junction box is being used, connect the wall bracket to the wall with drywall
anchors or wood screws.
2.
Connect the black wire from the “pigtail” wire harness to the black wire in the junction box.
Connect the white wire from the wire harness to the white wire in the junction box.
3.
Plug the wire harness into the back of the Rad-DX unit.
4.
Press the Rad-DX onto the wall bracket and make sure it is secure. It will snap into place.
The Rad-DX can be removed from the bracket by lifting the top tab with a flathead
screwdriver.
Figure 2: Junction Box Mounting Method
