xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Sw itch
23
7.
Under Properties, select VT100 for Emulation mode.
8.
Select Terminal keys for Function, Arrow, and Ctrl keys. Ensure that you select Terminal keys (not Windows keys).
9.
After you have correctly set up the terminal, plug the power cable into the power receptacle on the back of the Switch.
The boot sequence appears in the terminal.
10.
After the boot sequence completes, the console login screen displays.
11.
If you have not logged into the command line interface (CLI) program, press the Enter key at the User name and
password prompts. There is no default user name and password for the Switch. The administrator must first create user
names and passwords. If you have previously set up user accounts, log in and continue to configure the Switch.
12.
Enter the commands to complete your desired tasks. Many commands require administrator-level access privileges. Read
the next section for more information on setting up user accounts. See the
xStack
®
DGS-3600 Series CLI Manual
on the
documentation CD for a list of all commands and additional information on using the CLI.
13.
When you have completed your tasks, exit the session with the logout command or close the emulator program.
14.
Make sure the terminal or PC you are using to make this connection is configured to match these settings.
If you are having problems making this connection on a PC, make sure the emulation is set to VT-100. You will be able to set the
emulation by clicking on the
File
menu in you HyperTerminal window, clicking on
Properties
in the drop-down menu, and then
clicking the
Settings
tab. This is where you will find the
Emulation
options. If you still do not see anything, try rebooting the
Switch by disconnecting its power supply.
Once connected to the console, the screen below will appear on your console screen. This is where the user will enter commands
to perform all the available management functions. The Switch will prompt the user to enter a user name and a password. Upon
the initial connection, there is no user name or password and therefore just press enter twice to access the command line interface.
DGS-3627 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 3.00.B11
Copyright(C) 2012 D-Link Corporation. All rights reserved.
UserName:
Figure 4- 1. Initial screen after first connection
NOTE:
When you use HyperTerminal with the Microsoft® Windows® 2000 operating system, ensure
that you have Windows 2000 Service Pack 2 or later installed. Windows 2000 Service Pack 2 allows
you to use arrow keys in HyperTerminal's VT100 emulation. See www.microsoft.com for information
on Windows 2000 service packs.
Содержание xStack DGS-3600 Series
Страница 1: ...xStack DGS 3600 Series Layer 3 Managed Gigabit Ethernet Switch i ...
Страница 66: ......
