D-Link DWS-1008, Руководство по установке, Страница: 8 / 16

8 D-Link Systems, Inc.
DWS-1008 Install Guide Getting Started
3. Observe the power supply LED for each connected power supply to
verify that the LED is steadily glowing green. This indicates normal power
supply operation.
Connecting to a Serial Management Console
Initial confi guration of the DWS-1008 switch requires a connection to the
switch’s CLI through the serial console port.
To connect a PC to the serial console port:
1. Insert the serial cable into the PC port.
2. Insert the other end of the cable into the serial console port on the switch.
3. Start a standard VT100 terminal emulation application on the PC, and
confi gure the following modem settings:
• 9600 bps
• 8 bits
• 1 stop
• No parity
• Hardware fl ow control off or disabled
4. Open a connection on a serial port. If the switch is already powered on, press
Enter three times to display a command prompt. Refer to the “Accessing
the CLI” for more information.
Troubleshooting a Serial Management
Connection
1. Verify that the switch is powered on.
2. Verify that the serial cable is fully inserted in the PC and switch’s console
ports.
3. Verify that the correct modem settings are confi gured in the terminal
emulation application as shown in step 3 above.
4. Verify that you opened the connection on the PC port connected to the
switch. For example, if you inserted the cable in PC port COM1, make
sure you open the connection on COM1 instead of COM2 or another port.
If none of the previous steps results in a management connection, use
another serial cable.
Getting Started (continued)