D-Link DirectPort DMF-560TXD, Руководство пользователя

Страница: 37 / 79

- 31 -
C:If both modems are using MNP or V.42 protocol,
then the flow control may not be enabled.
A:Configure your software to use RTS/CTS flow
control. That will cause your computer to pause
long enough for the file to be stored to disk.
Q:The text on the screen is not legible.
C:Your software settings may not match the settings
on the remote site.
A:Make sure your data bits, stop bits, and parity
settings match the settings that the other computer
is using. The two most common settings are: 8 data
bits, None parity, and 1 stop bit (8,N,1) or 7 data
bits, Even parity, and 1 stop bit (7,E,1).
C:If the telephone line is very noisy, you may see
corrupted data on your screen.
C:Due to poor telephone line conditions, the modem
may have fallen back to a slower communication
speed. You may need to change the baud rate
setting in your software to match this slower speed.
To return the modem to the higher speed,
disconnect the link and re-establish again.
Q:When using V.42bis or MNP5, some features
are disabled.
C:You may be using a non-streaming protocol, like
Xmodem or Ymodem to transfer files. Those are
fine unless you are using V.42bis or MNP5
A:When using V.42bis or MNP5, you should use a
streaming transfer protocol like Ymodem-G or
Zmodem.
A:Configure your software to use hardware flow
control (RTS/CTS ON).