DGS-3312SR Stackable Gigabit Layer 3 Switch
114
Using a 10.xxx.xxx.xxx IP address notation, the above example would give six network addresses and six subnets.
Any IP address from the allowed range of IP addresses for each subnet can be chosen as an IP address for an IP interface
on the switch.
For this example, we have chosen the next IP address above the network address for the IP interface’s IP Address:
VLAN Name
VID
Network Number
IP Address
System (default)
1
10.32.0.0
10.32.0.1
Engineer 2
10.64.0.0 10.64.0.1
Marketing 3
10.96.0.0 10.96.0.1
Finance 4
10.128.0.0
10.128.0.1
Sales 5
10.160.0.0
10.160.0.1
Backbone 6
10.192.0.0 10.192.0.1
Table 6- 2. VLAN Example - Assigned IP Interfaces
The six IP interfaces, each with an IP address (listed in the table above), and a subnet mask of 255.224.0.0 can be entered
into the
Setup IP Interface
window.
To setup IP Interfaces on the Switch:
Each VLAN must be configured prior to setting up the VLAN’s corresponding IP interface.
To set up IP interfaces, open the
Layer 3 IP Networking
sub-folder in the
Configuration
folder and then click
IP
Interfaces Settings
to open the following window:
Figure 5- 2. IP Interface Settings window
Click the
Add
button to configure settings for a new IP interface. If you want to change an existing IP interface, click on
the hyperlinked
Interface Name
in the list.
Figure 5- 3. IP Interface Settings window - Add
