D-Link DGS-3100 SERIES, Руководство CLI

Страница: 170 / 220

DGS-3100 Gigabit Ethernet Switch Manual
162
30
A
CCESS
C
ONTROL
L
IST
C
OMMANDS
The Access Control List commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameter
create access_profile
(Ethernet)
profile_id <value 1-15> [ethernet {vlan | source_mac <macmask 000000000000-
ffffffffffff> | destination_mac <macmask 000000000000-ffffffffffff> | 802.1p |
ethernet_type}]
create access_profile
(IP)
profile_id <value 1-15> [ ip {source_ip_mask <netmask> | destination_ip_mask
<netmask> | dscp | [icmp {type | code} | igmp {type} | tcp {src_port_mask <hex
0x0-0xffff> | dst_port_mask <hex 0x0-0xffff> | flag_mask } | udp {src_port_mask
<hex 0x0-0xffff> | dst_port_mask <hex 0x0-xffff>}]}]
config access_profile
(Ethernet)
profile_id <value 1-15> [add access_id [auto assign | <value 1-255>] [ethernet
{vlan <vlan_name 32> | source_mac <macaddr 000000000000-ffffffffffff> |
destination_mac <macaddr 000000000000-ffffffffffff> | 802.1p <value 0-7> |
ethernet_type <hex 0x0-0xffff>} ports <portlist> [permit {replace_priority <value
0-7> | rate_limit <value 3500-1000000>} | deny]
config access_profile
(IP)
profile_id <value 1-15> [add access_id [auto assign | <value 1-255>] [ip
{source_ip <ipaddr> | destination_ip <ipaddr> | dscp <value 0-63> | [icmp {type
<value 0-255> code <value 0-255>} | igmp {type <value 0-255>} | tcp {src_port
<value 0-65535> | dst_port <value 0-65535> | flag <flag 1-24>} | udp {src_port
<value 0-65535> | dst_port <value 0-65535>}]} ports <portlist> [permit
{ replace_dscp <value 0-63> | rate_limit <value 3500-1000000>} | deny]
config access_profile profile_id <value 1-15> delete access_id <value 1-255>
delete access_profile profile_id <value 1-15>
show access_profile {profile_id <value 1-15>}
Each command is listed in detail, as follows:
create access_profile (Ethernet)
Purpose To create an access profile on the Switch by examining the Ethernet
part of the packet header. Masks entered can be combined with the
values the Switch finds in the specified frame header fields. Specific
values for the rules are entered using the
config access_profile
command, below
Syntax
create access_profile profile_id <value 1-15> [ethernet {vlan |
source_mac <macmask 000000000000-ffffffffffff> |
destination_mac <macmask 000000000000-ffffffffffff> | 802.1p |
ethernet_type}]
Description The
create access_profile
command creates a profile for packets
that may be accepted or denied by the Switch by examining the
Ethernet part of the packet header. Specific values for rules
pertaining to the Ethernet part of the packet header may be defined
by configuring the
config access_profile
command for Ethernet, as
stated below