1 Product Introduction
D-Link Web Smart Switch User Manual
3
3
the switches with other third-party devices for management in an SNMP-enabled environment. D-Link Web
Smart Switches also come with the D-View plug-in module that works with D-View 6 SNMP Management
Software, and provides easy-to-use graphic interface and facilitates the operation efficiency.
DGS-1210-28
24-Port 10/100/1000Mbps plus 4 SFP Slot Web Smart Switch.
Front Panel
Figure 1.1 – DGS-1210-28 Front Panel
Power LED
:
The Power LED lights up when the Switch is connected to a power source.
Port Link/Act/Speed LED (1-24):
The Link/Act/Speed LED flashes, which indicates a network link through
the corresponding port. Blinking indicates that the Switch is either sending or receiving data to the port.
When a port has an amber light, this indicates that the port is running on 10M or 100M. When it has a green
light it is running on 1000M.
Port Link/Act/Speed LED (25F, 26F, 27F, 28F):
The Link/Act/Speed LED flashes, which indicates a
network link through the corresponding port. Blinking indicates that the Switch is either sending or receiving
data to the port. When a port has an green light, this indicates that the port is running on 1000M.
Reset:
Press the Reset button for 5 seconds to reset the Switch back to the default settings. All previous
changes will be lost.
CAUTION:
The MiniGBIC ports should use UL listed Optical
Transceiver product, Rated Laser Class I. 3.3Vdc.
Rear Panel
Figure 1.2 – DGS-1210-28 Rear Panel
Power:
Connect the supplied AC power cable to this port.
DGS-1210-28P
24-Port 10/100/1000Mbps plus 4 SFP Slot Web Smart PoE Switch.
Front Panel
Figure 1.3 – DGS-1210-28P Front Panel
Power LED
:
The Power LED lights up when the Switch is connected to a power source.
Pwr Max:
The Pwr Max LED lights up when the Switch reaches the maximum power budget defined by the
administrator via PoE System Settings page of Web GUI or the default power budget of 193 Watts.
Reset:
By pressing the Reset button for 5 seconds, the Switch will change back to the default configuration
and all changes will be lost.
