D-Link DFM-562E, Руководство пользователя

Страница: 3 / 30

D-Link DFM-562E External Modem User’s Guide
3
Notices to Australian users:
The modem card must only be used in a data terminal equipment (DTE) e.g. computer, that has a screw
down cover (lid). As unsafe voltages (TNV) exist on the modem card, disconnect the modem card from the
telephone line while the cover (lid) of the DTE (computer) is removed.
Installation of the modem card in a DTE (computer) which does not require a tool to open the cover (lid) will
render the permit void.
Disconnect the telephone line before opening the cover (lid) of the DTE (computer). Do not connect the
customer equipment to the telephone line while the cover (lid) of the DTE (computer) is open.
Modems connected to the Australian telecommunications network must be marked in accordance with the
Labeling Notice. This modem has been specifically configured to ensure compliance with the ACA
Standards. Do not adjust your modem or software outside the values indicated as below. To do so would
result in your modem being operated in a non-compliant manner.
Modem Commands:
Command Default Permissible Range
ATA - Do not use
ATB B0 Do not set to B1
AT&G &G0 &G2
AT&P &P0 &P1
ATSn see table below
Call Attempts/Retries:
Applications software shall be configured so that no more than 3 attempts are made to establish a
connection to a given number (Note: if the modem can detect service tones, up to10 attempts can be made).
If the call sequence is unsuccessful, there shall be a delay of at least 30 minutes before attempting to call the
number again.
Failure to set the modem and any application software used with the modem, to the values shown as
above will result in the modem being operated in a non-compliant manner. Consequently, this would be in
violation of the Labeling Notice for this equipment, and the Telecommunications ACT 1997 prescribes
penalties for the connection of non-compliant equipment.
WARNING
FOR SAFETY REASONS, ONLY CONNECT EQUIPMENT WITH A
TELECOMMUNICATIOS COMPLIANCE LABEL. THIS INCLUDES
CUSTOMER EQUIPMENT PREVIOUSLY LABELLED
PERMITTED OR CERTIFIED.
WARNING
ONLY CONNECT EQUIPMENT WITH A TELECOMMUNICATIONS
COMPLIANCE LABEL