D-Link DES-3326SRM, Руководство по эксплуатации продукта

Страница: 45 / 242

D-Link DES-3326S Layer 3 Switch
Switch IP Settings
Switch IP settings may initially be set using the console interface prior to connecting to it through the Ethernet. If the Switch IP
address has not yet been changed, read the Introduction of the CLI Reference or read the instructions below on how to use the
console port and CLI IP settings commands to establish IP
settings for the Switch.
To change IP settings using the web manager you must access
the
Basic Switch Setup menu located in the Basic Setup folder.
To configure the Switch’s IP address:
Open the Basic Setup folder and click the Basic Switch Setup
menu button. The web manager will display the Current
Switch IP Settings at the top of the menu interface. Use the IP
settings fields under New Switch IP Settings to change the IP
settings on the Switch. Follow the instructions below.
It is also possible to provide
Name , Location and Contact
information in this menu.
NOTE: the Switch’s
factory default IP address
is 10.90.90.90 with a
subnet mask of 255.0.0.0
and a default gateway of
0.0.0.0.
Figure 3- 3. Configure Switch IP Settings
To manually assign the Switch’s IP address, subnet mask, and default gateway address:
1. Select Manual from the Get IP From drop-down menu.
2. Enter the appropriate IP address and subnet mask.
If you want to access the Switch from a different subnet from the one it is installed on, enter the IP address of the gateway. If
you will manage the Switch from the subnet on which it is installed, you can leave the default address (0.0.0.0) in this field.
If no VLANs have been previously configured on the Switch, you can use the default VLAN ID (VID) 1. The default VLAN
contains all of the Switch ports as members. If VLANs have been previously configured on the Switch, you will need to enter
the VLAN ID of the VLAN that contains the port connected to the management station that will access the Switch. The Switch
will allow management access from stations with the same VID listed here.
To use the BOOTP or DHCP protocols to assign the Switch an IP address, subnet mask, and default gateway address:
Use the Get IP From: <Manual> pull-down menu to choose from BOOTP or DHCP . This selects how the Switch will be
assigned an IP address on the next reboot.
35