ENGLISH
ENGLISH
INSTRUCTIONS FOR TREATMENT
It is recommended to carry out the Spot test (see above) at least 24hrs prior to treatment to choose a
safe treatment level for your skin.
How to treat
1. Charge Sense Laser (page 4).
2.
Prepare your skin for treatment (see page 4).
3. Pick the main unit up o
ff
the charging station once the battery is full.
4.
Press the power button to turn on the unit. The device sets itself on the lowest energy level (first blue LED
lighting).
5. Use the power button to increase the energy level to reach the level determined in the spot test and accord-
ing to your convenience. Another blue LED will light with each level increased up so then, the number of the
level will correspond to the same number of blue LED lighting at the same time.
6.
Place the treatment window flat against your skin, the device will start shooting automatically and you will
hear a continuos beep. If you do not hear the beep, make sure that the treatment window is in perfect touch
with your skin.
Important Note
: Dependent on the energy level selected the device should be moved different over the skin (2
different operation modes (see page 1)
Level 1 to 3, Multiple Pass Technique (HRR) will be used
.
This mode consists of maintaining Sense Laser over the area to be treated and in constant motion. In this mode
it is necessary to repeatedly pass the device over the same area up to 5 times to ensure maximum coverage.
The higher the level the slower you will need to glide the device. This is because the more energy released,
the slower the pulse rate. If Sense Laser stop shooting while moving it, just lift it and place it back on the skin to
start shooting again.
Level 4 and 5, Single Pass Technique (LRR):
This mode is performed by shooting only one shot over the treated area so then, move Sense Laser to next
patch and shooting again ensuring there are no gaps or overlaps in the treated area. It is recommended to
move the unit about the distance of the window (10 mm). DO NOT treat repeadtedly in the same spot to prevent
discomfort or skin heating. Using this mode, the device will only shot again after lifting the unit and placing it
back on the skin.
Repeat steps 5 until all the chosen area has been completely treated.
The product should not be used for
more than 30 minutes at one time. After 30 minutes are up, switch the device off and place it on the
charging station.
NB: If the device is left on but not used for approximately 3 minutes it will automatically switch
itself off. If this has happened, press the power button to turn the device back on.
Facial treatment
The facial skin is a sensitive area that requires special care and caution. Make sure you follow all instructions
and safety precautions carefully in order to avoid adverse effects.
It is recommended to only use Level 1 to 3 for facial treatments.
Warning!
Do not use the device on the face above the cheek line, around the eyes, eyebrows or eyelashes as this could
cause serious eye damage.
Do not use the device to treat hair growth in the nose and ears.
Make sure you do a spot test 24 hours prior to treatment to determine suitability. The Spot Test can be carried
out on a hair-free area such as below the ear or the side of the neck. Despite the result of the spot test, it is
highly recommended to always start any facial treatment with Sense Laser set up in level 1.
Warning!
Use a mirror to help you place the applicator correctly on the treatment area.
Follow the instructions for use (see page 5) with additional care to the following specific area instructions.
Note
:
Facial Hair may be hormonal and as such, it can take more sessions to achieve a permanent hair reduction.
Upper Lip Treatment
Place the treatment window on the area as indicated in the picture. Repeat up to 5 times on each area.
Avoid the nostrils and lip, as these areas are more sensitive. If needed mask the lips with a sheet of paper.
You can “fold” your lip inward or press the lips together to achieve a better spread treatment area.
Cheek and Jaw treatment
Place the Applicator treatment area as indicated in the picture. Treat each area up to 5 times, moving from one
side of the jaw/cheek to the other.
Neck and chin treatments
Place the Applicator treatment area as indicated in the picture. Treat each area up to 5 times, moving from one
side of the neck/chin to the other.
Note:
The skin on lower third of the neck is more sensitive.
Post treatment care
z
Apply a calming lotion such as D Light Post tratment cream.
z
Avoid using peeling and bleaching creams or products for at least 24 hours as this irritates the treated skin.
z
Avoid more than 15 minutes of direct sun exposure for at least 1 weeks post treatment. If recently treated skin
is exposed to sunlight in this time period, make sure to apply SPF 30 or higher sunscreen.
z
Do not wax or pluck hairs from treated areas.
EN-6
EN-7
