D.A.S. DSP-2040, Руководство пользователя

Страница: 23 / 32

19
Unlocking the Unit
To unlock the unit press ENTER and then type the code in. This can be entered by using the FREQ
control to select a character, and the BACK and NEXT keys to move to the next character. Alternatively, the
EDIT keys can be used to enter a code by pressing any combination of the eight buttons. Each EDIT key
represents its channel labelling, as described in the locking section.
Forgotten the Password?
Don't panic! Your unit can still be unlocked. In an attempt to improve the security system on the
DSP-
2060
, and prevent a standard master password from becoming common knowledge, the units now have a
random password key generator.
The procedure for unlocking a unit using the password override is explained below:
Switch the unit on with the MENU key held in momentarily. After a few seconds, the unit will ask for a
security code. Use the EDIT keys in the same manner as for entering lock codes (see page 20 for details)
and enter 2121.
The display will show:
Enter XTA Supplied Code:
Break Code = 12345 [NNNN]
The Break Code (in the example 12345) should be noted and supplied to DAS. We have software to
generate the corresponding Pass Code which should be typed in, followed by ENTER. This will unlock the
unit and wipe the previous password.
Note the following about this procedure:
Once the Break Code has been noted, do NOT press MENU again during the operation of the unit
(except to get back to this point on power up), or a different code will be generated. The unit may be used as
normal, but every press of MENU will change the Break Code, so the Pass Code we provide will not work!
The unit may be switched on and off as necessary – just be sure NOT to press MENU, or the entire Break
Code procedure will have to be repeated.
Manual de Usuario
DSP-2040