4
•
It is a legal requirement to run all cabling in conduit. The power supply must be run in a
separate conduit to ANY other cables.
•
Mains supply may only be run in a guarded cable. Under no circumstances may 230V/AC be
run using Communication cable, Ripcord or Cabtyre.
•
Ensure that all electrical power is switched off before any electrical connections are made.
•
Do not open, tamper or modify any of the electrical components of this equipment in any way.
•
Do not attempt to repair the equipment, this should only be done by a qualified D.A.C.E. tech-
nician.
•
D.A.C.E will not be held liable for any accident / incident resulting in damage, injury or death
ensuing from the installation of the automatic gate operator.
•
Although these operators have built-in collision sensing, substantial damage may still occur.
For this reason DuraOptics safety beams should be used on all installations.
•
Do not allow children to play near or with any gate, gate operator or remote control.
•
It is the responsibility of the installer to ensure that the gate is in good working condition before
automating the gate.
•
D.A.C.E cannot be held responsible for any gates bumping the ends stops when a gate on a
slope is automated.
•
It must be noted that an automatic gate is a heavy piece of equipment and injury, even death,
may occur due to incorrect installation or operation of the equipment. There are a number of
areas that may cause entrapment which could lead to injury.
•
Do not operate the gate unless within direct sight.
INTRODUCTION, RECOMMENDATIONS & LEGAL REQUIREMENTS cont.
RECOMMENDED TOOLS
●
Drilling machine
●
Steel & masonry drill bits
●
8mm / 13mm / 17mm Spanners
●
Assorted screwdrivers
●
13 / 17mm Socket
●
Spirit level
●
Spade
●
Pick
●
Multimeter
●
Tape measure
•
Wire cutters
●
Angle grinder
●
Hacksaw
●
Hammer
Shaded areas show the possible entrapment areas of an automated gate.
