27
To set multi-user mode, place number 5 dipswitch in the ON position.
NOTE !!! If Multi-user is selected, an auto-close time must also be selected. If an auto-close
time is not selected, the gate will immediately close after opening.
MULTI-USER MODE
No.5:
ON FOR MULTI-USER
Step1:
place the jumper over the two pins called
TX-E
and count 4 flashes on the yellow LED on the
receiver.
Step2:
remove the jumper.
Step 3:
replace the jumper and count 2 flashes on the LED.
Step 4:
remove the jumper.
Step 5:
replace the jumper and count 4 flashes on the LED
The LED will now flash rapidly for one second to indicate that all remotes have successfully been
erased.
NOTE: The time between the jumper being removed and replaced on the pins
must NOT exceed 2 seconds.
To program remotes to the on-board receiver complete the following steps. It is recommended that the
remotes are numbered in order of programming. This will assist with erasing any lost or stolen remote
at a later stage.
Step 1:
press and hold the button that is to trigger this application on the remote. It is important that
this button is continuously held from step 1 through to 3.
Step 2:
place the jumper over the two pins on the PC Board called
TX- L
for 2 seconds.
Step 3:
remove the jumper from the two pins.
Step 4:
release the button on the remote.
That particular button on the remote is now programmed to the receiver.
PROGRAMMING THE REMOTES
If the remotes are not numbered all remotes will need to be erased and reprogrammed once again. If
all remotes are numbered it is possible to erase a single remote. The preceding remote is needed to
erase the required remote. For example remote number 6 will erase remote number 7 etc.
Step 1:
place the jumper over the
TX-E
pins.
Step 2:
press the button of the preceding remote.
Step 3:
remove the jumper.
The remote will now be erased. The next remote to be programmed will take the place of the erased
remote. In this example it will take the place of number 7 and must be numbered as such.
4
3
2
1
ERASING ALL REMOTES PROGRAMMED TO THE RECEIVER
ERASING A SINGLE REMOTE PROGRAMMED TO THE RECEIVER
