Product User’s Manual –
Side View
1. Connector for UIC00B Programmer
2x5 box header for UIC00A/B, USB ICSP PIC Programmer.
2. JP10 for PICkit
JP10 port reserved for PICkit programmer. User may use PICkit3 and plug to this port and
utilize the ICSP pin to load program besides using UIC00B.
3. UART connector
Reserved for UART communication. Tx and Rx pin of SK40C are connect to RC6 and RC7
respectively. Ensure PIC Microcontroller chosen has the correct UART pin (RC6 and RC7).
4. LED Indicator
2 LEDs (connected to RB6 and RB7) as active High output for PIC MCU. These LEDs are
controllable from PIC MCU.
5. Programmable Push Button
2 x Push button (Tactile switch) connected to RB0 and RB1 of PIC MCU. This is extra input
button for user. It can be programmed as input switch.
6. Reset Button
Push button with the function of Reset for PIC MCU.
7. 40-Pin IC socket for PIC MCU
40 pin IC socket for user to plug in any 40 pin PIC MCU (8-bit and 5V operated). It can either
be 16F or 18F PIC. Of course the IC package should be
.
Please ensure the first pin is
at the top side.
Inside IC socket, there some electronics components.
8. LCD Contrast
5K of trimmer to set LCD contrast.
9. JP9 for USB
JP9 is provided for USB usage. Connect these pins if user uses USB communication. Shorting
Created by Cytron Technologies Sdn. Bhd. – All Rights Reserved
8
