Cyrus Mono X 200 Signature, Инструкция пользователя

Страница: 7 / 12

Cyrus Mono X 200 Signature & Mono X 300 Signature User Instructions
5
Remote Power Control (MC-BuS, RS232 or 12V Trigger)
The Mono X Signature may be remotely switched to and from Standby
(low power standby) using the Cyrus MC-BUS system or one of two
industry standard connection systems – RS232 or 12V trigger.
The Cyrus MC-BUS system is recommended for use when amplifiers •
are installed in a system of Cyrus audio components.
A 12V trigger feed is often used by AV receivers for standby control of
•
power amplifiers, projectors etc in an AV system.
The RS232 interface is found in some CI (custom install) multi-room
•
installations where the system control unit can remotely control the
system components including power amplifiers.
Connecting to an MC-BuS equipped Cyrus system
An MC-BUS (Master Control) loop is established by connecting single
phono cables from the MC-BUS output of one unit to the MC-BUS input
of another in a daisy-chain. Complete the loop by returning the MC-
BUS output of the final component to the MC-BUS input of the first (see
example system connections below).
1
9
+12V
0V
Connecting to a 12V trigger equipped system
A custom connection cable will be required to set up 12V trigger operation.
A retailer should be able to make up a cable of the correct length and with
the correct terminations to match the amplifier (9-pin D-type) and the
control unit.
The connections required are –
MC-BUS out
MC-BUS out
MC-BUS out
MC-BUS out
MC-BUS in
MC-BUS in
MC-BUS in
MC-BUS in
MC-BUS out
MC-BUS in
Cyrus CD Player
Cyrus Tuner
Cyrus Pre-amplifier
Cyrus Mono X
Signature
Cyrus Mono X
Signature
With MC-BUS established you can control the power function of the
system from the front panel or remote control of the main Cyrus amplifier
or Surround Processor.
Once the cable is available, connect the 9-pin D to the RS232/12V
connector
i
on the back of the Mono X Signature. Connect the other
end of the cable to the AV receiver or other component that is controlling
system power.
Connecting to an RS232 equipped system
Your CI installer can obtain full installation and programming instructions
for the RS232 interface from Cyrus technical support or from your local
Cyrus distributor.