PSoC™ 6 Wi-Fi Bluetooth® pioneer kit guide, Document Number. 002-22677 Rev. *I
27
Kit operation
29.
ICSP header compatible with Arduino (J5):
This header provides an SPI interface for shields
compatible with Arduino ICSP.
30.
PSoC™ 6 MCU current measurement jumper (J8, on the bottom side of the board):
An
ammeter can be connected to this jumper to measure the current consumed by the
PSoC™ 6 MCU.
31.
KitProg3 (PSoC™ 5LP) programmer and debugger (CY8C5868LTI-LP039, U2):
The
PSoC™ 5LP device (CY8C5868LTI-LP039) serving as KitProg3, is a multi-functional system,
which includes a programmer, debugger, USB-I2C bridge, USB-UART bridge, and a USB-SPI
bridge. For details, see the
.
See
Hardware functional description on page 36
for details on various hardware blocks.
For some devices in the PSoC™ 6 MCU family, simultaneous GPIO switching with unrestricted drive
strengths and frequency can induce noise in on-chip subsystems affecting CAPSENSE™ and ADC
results. For more details, see the Errata section of the corresponding
shows the functionalities of the on-board selection switches.
2.2
CY8CKIT-028-TFT details
2.2.1
CY8CKIT-028-TFT display shield
Figure 2-5. TFT display shield
Table 2-1. Selection Switches on the Pioneer Board
Switch
Location on the
Board
Purpose
Default
Position
SW5
Front
Selects the V
DD
supply of the PSoC™ 6 MCU between
1.8 V, 3.3 V, and the variable 1.8 V to 3.3 V, which is
controlled by KitProg3.
3.3 V
SW7
Back
Selects the VBACKUP supply connection of the PSoC™ 6
MCU between V
DDD
and the super-capacitor. When V
DDD
is selected, the regulator can be turned ON/OFF by
KitProg3. When the super-capacitor is selected, the
PSoC™ 6 MCU can turn the regulator ON/OFF.
VDDD/
KITPROG3
