CY8CKIT-149 PSoC® 4100S Plus Prototyping Kit Guide, Doc. #: 002-20729 Rev. *E
22
Kit Operation
3.2
Programming and Debugging the Target PSoC 4100S Plus Device
The target PSoC 4100S Plus device can be programmed and debugged using the KitProg2. Before
programming the device, make sure that PSoC Creator and PSoC Programmer software are
installed on the PC. See
for more information.
3.2.1
Programming Using PSoC Creator
1. Make sure SW4 is switched to PSoC side. Connect the prototyping board to the PC through the
USB Micro-B Connector (
J8
) as shown in
. The kit enumerates as a composite device.
If you are plugging in the PSoC 4100S Plus Prototyping Kit to your PC for the first time, the kit
drivers will get installed automatically. The amber status LED (LED3) will turn ON to indicate suc-
cessful enumeration. If the amber status LED (LED3) is OFF, see the
for
details on the KitProg2 status and troubleshooting instructions.
Figure 3-2. Connecting the PSoC 4100S Plus Prototyping Kit to a Computer
2. Open the desired project in PSoC Creator. From the PSoC Creator, go to
File
>
Open
>
Project/
Workspace
. You can browse and open a previously saved project. If you want to open one of the
code examples provided with the kit, follow the instructions in the
