Appendix
CY8CKIT-044 PSoC® 4 M-Series Pioneer Kit Guide, Doc. No. 001-96598 Rev. *C
22
2. Open the desired project in PSoC Creator. For this, go to
File
>
Open
>
Project/Workspace
. This provides the option
to browse to and open your saved project.
3. Select the option
Build
>
Build Project
or pressing
[Shift]
[F6]
to build the project.
4. If there are no errors during build, program the firmware into the kit by choosing
Debug
>
Program
or pressing
[Ctrl]
[F5]
. This programs the device on the PSoC 4 M-Series Pioneer Kit.
3.3.2 Debugging using PSoC Creator
PSoC Creator has an integrated debugger. You can start the debugger by selecting
Debug
>
Debug
or by pressing
[F5]
.
Refer to section 3.2 of the
KitProg User Guide
for a detailed explanation on how to debug using PSoC Creator.
3.3.3 Programming using PSoC Programmer
PSoC Programmer (3.22.2 or later) can be used to program existing
.hex
files into the PSoC 4 M-Series Pioneer Kit. Refer
to section 3.3 of the
KitProg User Guide
for a detailed explanation on how to program using PSoC Programmer.
3.4 USB-UART Bridge
The KitProg on the PSoC 4 M-Series Pioneer Kit can act as a USB-UART bridge. The UART lines between the PSoC
4200M and the KitProg are hard-wired on the board, with UART_RX assigned to
P7[0]
and UART_TX assigned to
P7[1]
on
PSoC 4200M. For more details on the KitProg USB-UART functionality, refer to the
KitProg User Guide
.
3.5 USB-I2C Bridge
The KitProg can function as a USB-I2C bridge and communicate with the software utility Bridge Control Panel (BCP). The
I2C lines on PSoC 4200M device are
P4[1] (SDA)
and
P4[0] (SCL)
, which are hardwired on the board to the I2C lines of
the KitProg. The USB-I2C supports I2C speeds of 50 kHz, 100 kHz, 400 kHz, and 1 MHz. For more details on the KitProg
USB-I2C functionality, refer to the
KitProg User Guide
.
3.6 Mass Storage Programmer
The KitProg in PSoC 4 M-Series Pioneer Kit supports programming through a USB Mass Storage interface. This interface
allows you to program the PSoC 4200M by copying
.hex
files into an emulated USB Mass Storage device. For more details
on KitProg Mass Storage Programmer, refer to the
KitProg User Guide
.
3.7 Updating the KitProg Firmware
The KitProg firmware normally does not require any update. You can use the PSoC Programmer software to update the
KitProg firmware. Refer to the
KitProg User Guide
for a detailed explanation on how to update the KitProg firmware.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
