Cypress CY4532 EZ-PD CCG3PA, Начало работы

Страница: 6 / 25

Getting Started with EZ-
PD™ CCG3PA
www.cypress.com
Document No. 002-18179 Rev. ** 6
Figure 3. CY4532 EZ-PD CCG3PA EVK Architecture Block Diagram
24 Pin Debug Connector
M
in
iP
ro
g
3
CCG3PA
Battery
Charger
BUCK
BOOST
Type-A
Current
Sense
5V
LDO
5V
Regulator
USB-
SERIAL
24 Pin Connector
Interface to Power Board
Mini USB
Receptacle
Battery Input
Terminal
Screw Connector
for DC Load
Screw Connector
for VBus
12V DC Jack
Switch
Type-A
Receptacle
Type-C
Receptacle
CCG4
I2C CC
Type-C
Receptacle
The CY4532 EVK supports mobile power adapters, PC power adapters, power banks, car chargers, and other
applications that primarily charge other devices via a Type-C interface. The kit is intended as an evaluation vehicle for
USB Host systems that house a Type-C connector. Refer to the CY4532 EZ-PD CCG3PA EVK Guide for in-depth
information about EVK use cases.
The CY4532 Main Board consists of the following:

CCG3PA silicon (CYPD3171-40LQXIT)

Type-C port

Type-A ports

MiniProg3 SWD header
Debug header The CY4532 Power Board consists of the following:

DC Input

Battery Input Terminal

Mini-USB interface (to download firmware into CCG3PA)

Type-C port (to enable flashing of an external CCG3PA-based hardware)

Regulators (to support battery charging and provide power for the Type-C interface)

Type-A charging
The Main Board is mounted on the Power Board using two sets of connectors.
The CY4532 CCG3PA silicon contains overvoltage protection (OVP) and overcurrent protection (OCP) circuitry for
VBUS and supports EZ-PD CCG3PA device programming over the Type-C interface.