© 2009 Cypress Solutions
Complete Manual: CTM-15X Firmware 1.2.0
(Revision 1.0)
103
6BCommand Reference
cmd odometer
cmd smstext
cmd enghours
The below commands are not supported in either
showconfig
or showstate commands. To configure
these commands the
showconfig
script file or input text must be manually updated.
cmd factory
cmd telnetpswd
Commands can be manually entered as shown in the output of
showconfig
using the syntax shown. The
showconfig
output can be 'Copy & Pasted', if there is a long list of commands, it is recommended to use a
telnet session rather than the serial console to capture the output of
showconfig
.
Example:
cmd showconfig
returns the current modem configurations
return to list of commands
showstate
Returns the current state of the modem.
This is a read only command.
showstate
returns the modem state:
•
firmware revision
•
modem ESN
•
modem ID
•
modem IP address
•
odometer
•
engine hours
•
RF Switch output mode, 0 = RF device connected or connecting, 1 = RF device off, awaiting switch
input.
•
sms text.
Example:
# cmd showstate
Firmware Version:CTM15x R1.2.0_RC8 (rev. 1246)
ESN:09604890958
Modem ID:09604890958
Modem IP Address:72.25.230.27
Odometer:0 KM
Engine Hours:0.00 h
Output mode (RF Switch):0