1. Kit Contents
Each CY3280-CPM1 CapSense
®
Plus Module Development Kit contains:
■
CY3280-CPM1 CapSense Plus Module Board
■
CY3280-CPM1 Kit CD
■
Quick Start Guide
Universal CapSense Module boards are available for purchase separately. For more
information, visit
http://www.cypress.com/shop
.
Prerequisites:
■
CY3280-22x45/CY3280-28xxx Universal CapSense Controller Board
■
PSoC MiniProg
■
USB Mini-B Cable
2. Module Hardware
Buttons
Thermistor
40-Pin
Connector
Loopback Jumper for
SPI Communication
Potentiometer
Reserved for
Speaker Driver
Reserved for
Speaker
LED Bar
LEDs
LED Panel
Reserved for
Thermocouple
Page 2
Page 3
The module board consists of an LED panel, a potentiometer, an LED bar, six LEDs, a
thermistor, and two buttons. These are interfaced to the CapSense Controller board
via a 40-pin receptacle connector (J2). The board also consists of two loop-back
connection jumpers (JP3 and JP4) to demonstrate the variable length SPI master-
slave communication.
3. Getting Started
CY3280-CPM1 kit can be connected to the CY3280-22x45 or CY3280-28xxx
Universal CapSense Controller boards. Insert the kit CD into the CD/DVD drive of your
PC and follow the instructions to complete the installation.
4. Board Setup
This section uses one example firmware to demonstrate the setup of CY3280-CPM1
with CY3280-20x45 Universal CapSense Controller board. Similar procedure is
followed for the CY3280-28xxx board. Refer to the CY3280-CPM1 kit guide for more
examples.
4.1 Real Time Clock (RTC) Setup
1.
Connect the CY3280-CPM1 board to the CY3280-22x45 Universal CapSense
Controller board's P2 receptacle connector.
2.
Connect your PC to the CY3280-22x45 Universal CapSense Controller board's
ISSP connector (J3) using a PSoC MiniProg and an USB cable.
Downloaded from
Downloaded from
Downloaded from
