CYP IP-7000TXWP, Руководство по эксплуатации, Страница: 25 / 52

20
„
Unicast:
This mode uses a discrete video stream between the
transmitter and every connected receiver and is ideal for simple,
point-to-point, streaming setups. This mode uses considerably
more bandwidth than Multicast mode when multiple receivers
are being used, however it does not require a network switch that
supports IGMP snooping.
6.5.4 Functions Tab
The Functions tab provides control over the unit’s AV source management,
and streaming bandwidth/quality settings, as well as defining how USB
and serial signals are handled. Changes made to these settings typically
require a reboot of the unit. After clicking on “Apply” please follow the
reboot instructions in the WebGUI, if necessary.
1) Video over IP:
This section allows control over the streaming bit rate
and quality.
„
Source Selection:
Select the preferred input source, HDMI or
VGA or enable the auto scan function of the unit by checking the
"Enable Auto Scan" checkbox.
Note: Once searching for a new source begins, the input will
automatically switch back and forth until a valid video source is
detected.