CYP EL-8100V, Руководство по эксплуатации

Страница: 41 / 80

36
3) System:
This section provides control over trigger configuration,
remote control ID, and saving/restoring the system’s configuration.
„
Remote Control:
Use the dropdown to select the custom code
pairing that matches the dipswitch settings of the IR remote you
wish to use.
Note: The dipswitches on the IR remote are located under the battery
compartment cover.
„
Trigger In 1~5:
Use each dropdown to set the input to be selected
when the associated trigger is activated.
„
Reset Trigger In: Press the “EXE” button to reset all trigger settings
back to their factory defaults.
„
Configuration Save:
To export a configuration to your PC, click the
“SAVE” button and then select the preferred save location on the
local PC. Next, click the “Save” button to complete the file export.
„
Configuration Upload: To load a previously saved configuration
from your PC, click the “UPLOAD” button to open the file selection
window and then select the associated configuration (*.xml
format) located on your local PC. After selecting the file, click the
“Open” button to import the new configuration. The associated
configuration will then be restored.
4) Ethernet:
This section provides a way to change the unit’s Ethernet
related settings and displays the unit’s MAC address as well.
„
IP Mode:
The unit’s IP mode may be switched between Static IP
and DHCP. In Static IP mode the IP, netmask and gateway addresses
may be manually set. When in DHCP mode, the unit will attempt to
connect to a local DHCP server and obtain IP, netmask and gateway
addresses automatically. Please press “Save” after making any
changes to the IP configuration or mode.
Note: If the IP address is changed then the IP address required for
WebGUI/Telnet access will also change accordingly.
„
Telnet Login:
Enable or disable requiring authentication when
connecting via Telnet.
5) Reset: Press either of the “EXE” buttons to reset the unit’s settings back
to their factory defaults. Selecting the “All Except Ethernet” button will
leave the current Ethernet settings intact after the reset is complete.