CYP CR-CS2, Инструкции по эксплуатации

Страница: 16 / 24

12
12
Click on the icon to edit each button’s macro.
Click on the mark to edit the command settings.
Up/down
arrows are to move the command up or down and button is to
delete the command.
Click on Insert button/Add to insert commands. Command can be
set to control the Control System/SysCMD, other devices connected
within the same Telnet system/Internet area, RS-232 COM ports, IR and
Relay devices connected through the Relay outputs of Control System
with delay time. It is suggested the delay time is >100ms once the
setting is confi med, double click on Save Change.
Command set to control the devices within the same telent system
or internet area require to set its IP and Port number and it is strongly
recommand to set the delay time >500ms in order to secure a
successful command sending. Command set to control the Relay
devices require to set the Port number. Click on Save Change to
confi rm the setting.
13
At the top of the Macro edit window is a text fi eld where you can edit
the name of the macro. Type your new macro name into the box and
then click the icon to save it.
Within the edit window the up/down arrows will change the
command’s execution order. The icon allows you to edit the delay
and interface for the command. The icon will delete the command.
Click on the icon to insert a new command before the current one.
Select one of the pre-defi ned commands from the list. (Details on how
to create these pre-defi ned commands are later in this section)
After selecting a command, you will need to choose the delay and
interface for the command.
The “Delay(ms)” setting is the length of time to wait before sending
the next command and is set in milliseconds. The interface for sending
commands can be set to the unit itself (SysCMD), to a specifi ed IP
address (TELNET), to the RS-232 port (COM), to a specifi ed IR port (IR)
or to trigger a relay port (Relay). Click on “Save Change” to confi rm
the settings.
Sending commands to devices on the local network, or across the
internet requires the IP address and network port number of the
destination device. Once the destination information is complete
please click on “Save Changes”.
Note: It is strongly suggested to not set a delay time less than 100ms for
system, RS-232, IR, and relay commands or less than 500ms for telnet
commands to ensure that the command is properly received and
executed before the next command is sent.
When you have fi nished editing the macro click on “Save Change”.