CYP CH-U331TX, Руководство по эксплуатации

Страница: 33 / 88

29
Ethernet settings of the unit. It also provides an easy way to find the
physical unit when installed with many other similar units.
- IP Mode & Settings: The IP mode may be switched between “Auto
IP”, “DHCP” or “Static IP”. When the unit is set to Auto IP mode it
will automatically assign itself an APIPA address from the
169.254.xxx.xxx range. When the unit is set to DHCP mode it will
attempt to automatically obtain an IP address from a DHCP
server. When the IP mode is set to static IP, you can manually set
the IP address, netmask and gateway address. Click the “Apply”
button to save changes made to the IP Mode or Configuration.
Note: The default network setting for this unit is “Auto IP”.
- Find Your Device: Selecting “Show Me” will cause the unit to
immediately begin flashing the LEDs on the front of the unit to
make it easy to find. Selecting “Hide Me” returns the LEDs to their
normal behavior. This setting is useful when troubleshooting an
installation with a large number of units in a rack.
• Casting Mode
Allows for the selection of the broadcasting mode used by the
Transmitter. Click the “Apply” button to save changes made to the
broadcasting mode.
Note: Receivers must be set to the same mode as the Transmitter in
order to receive video.
- Multicast: This mode sends a single video stream that can be
viewed simultaneously by multiple receivers without increasing
bandwidth usage. This mode is ideal for video wall or matrixing
scenarios. Multicast mode requires a network switch with IGMP
snooping enabled.
Note: The 3 port network switch built into the Receiver units
supports IGMP snooping and may be used to distribute a multicast
stream.
- Unicast: This mode uses a discrete video stream for every
connected Receiver and is ideal for simple, point-to-point,
streaming setups. This mode uses considerably more bandwidth
than Unicast mode when multiple Receivers are being used,
however it does not require a network switch that supports IGMP
snooping.