ROTARY PERFORATING MACHINE RPM 350 PLUS
11
6.8
Dismounting of covers (3, 4)
The covers can be dismounted after work has been finished and fully disconnected from the
mains supply. Before resuming work the covers must be reattached and fixed. The covers can
be dismounted only by a trained employee.
Note: The covers can be dismounted
only when service interference, indented belt replacement
or feed roller pressure is required.
6.9
Separator pressure adjustment
The pressure of the separator on the wheel (27) of the feeding shaft must be adjusted in order
to secure the proper feeding of paper from the feeding table (1). Turn the wheel clockwise to
increase the pressure imposed on the separator. If a thicker sheet is introduced into the feeding
table, the pressure of the separator should be smaller.
7
REMOVAL OF DEFECTS
•
The machine won’t start but the red LED is on:
Make sure the upper cover (5) is closed properly and that the optical sensor on the
input feeding table operates properly (1).
•
Paper gets crumpled inside the machine:
Open the upper cover (5) and remove the paper from the machine. Make sure that
the feed roller turns freely and that it remains in the prescribed position according to
fig. A.
•
Several sheets are fed simultaneously:
Adjust the pressure of the separator (b) using the adjustment wheel (c).
•
The perforated cut is wide and frayed:
Make sure the blades are sharp and set the clearance between both tools. Both tools
must touch each other on the external, i.e. not beveled side. See fig. A.
•
The machine gets jammed and operates only heavily:
Check all mobile parts under the cover (5).
Make sure the blades are sharp and have not been crossed or misaligned.
8
MACHINE MAINTENANCE
Clean the machine once a month (dust and other impurities), concentrating on the inside of the
machine, especially in the area near the electric motor.
9
PROTECTION AGAINST DANGEROUS CONTACT WITH LIVE
PARTS
(ČSN 33 2000-4-41)
Covers and insulation, equipment and distribution lines engaged in operation.
10
MACHINE DISPOSAL AND TRANSPORT PACKAGING
When the machine has completed its service life, it can be disposed of together with communal
waste. The machine is then dismounted and metal, plastic, rubber, and electronic parts are
sorted to be handed in to respective salvage centers for further recycling. Machine parts are not
made from hazardous materials and as such can be disposed of as communal waste and their
liquidation by a specialized company is not necessary.
