Revision A.5
Cyclops Storm OSD tpalshadow English Translation
4
The above images show sample configurations for either 1- or 2-battery setups. Please note
these are only general samples and your particular installation may vary. The key difference
between the setups is in Sample 1 the main power battery also provides power to the STORM
OSD and your video equipment where in Sample 2 you have a separate battery for the STORM
OSD and video equipment.
NOTE:
The STORM OSD will provide 12V power to the camera and video transmitter. If your
camera or video transmitter do not support 12V power you are required to provide power
through an alternative method.
It is important to note that power from the receiver supply is used for the servos. Use three
wire leads (positive, ground and signal) for connecting the receiver to the STORM OSD and then
to the servos. When signal from the receiver is lost the STORM OSD will provide the signal to
the servos but the power continues to come from the receiver supply.
The following image describes the BAT jumper and it’s usage in more detail:
Important:
Choose the correct power jumper configuration:
To use the system power, short circuit pins 1 and 2. (System power must be 12V, or 3S
LiPo batteries)
For separate OSD/video 12V or 3S LiPo equipment battery, remove the jumper cap and
use pins 2 and 3.
