background image

 

 

 

Run the main fused power wire and ground wire back to the battery and grounding bolt 
under the seat, try to tuck and zip tie the wires out of the way of the exhaust or any 
heat affected areas. 

 

If you are using the skene Dimmer wire this in at this time, you can run both switched 
power wires together and use AUX port 2 for the switched power source, this is located 
in the back left side of the KTM headlight bucket. Its also ok to tie all ground wires 
together. 

 

If you are only using the light bar for ON/OFF operation run the cyclops wire that is 
labeled to switched power to the headlights high beam power wire, use the positap 
supplied to tap into the High beam wire 

 

Next if using teh Skene dimmer use the provided positap to pull signal power from the 
high beam power wire.  (White wire on skene controller) 

 

Connect the Cyclops light to the Cyclops power wire harness, if you’re not using the 
dimming function the yellow wire on the LED light bar will not be utilized.  

 

Make sure there are no wires interfering with the steering of the bike. 

 

 Once all wiring is complete, start the install of your belly pan with the Led light bar 
attached, point the light bar as far down as possible to allow access to the forward two 
attachment bolts. 

 

Install the middle two belly pan attachment bolts first, then move to the forward two 
bolts that go through the ears on the aluminum mount. 

Содержание KTM 1190 LED Light Bar

Страница 1: ... Remove the bikes headlight and set it aside make sure not to scratch the plastic lens Remove the belly pan around the forks under the headlight Once you have the belly pan removed use the cyclops aluminum bracket as a guide and drill the two inch holes for the Led light Bar mounts make sure the mount ears are in the pockets where the two forward screws that hold the belly pan on the bike Now dril...

Страница 2: ...the finish washers on the inner side Fish the power cord threw the inch hole then install the rubber grommet in the hole Its now time to move on to the wire harness install If you have ordered the Skene dimmable option fallow the included Skene Cyclops instructions Mount the relay into the back of the factory headlight bucket use a zip tie to fasten the relay to the rear of the headlight bucket Se...

Страница 3: ...dlights high beam power wire use the positap supplied to tap into the High beam wire Next if using teh Skene dimmer use the provided positap to pull signal power from the high beam power wire White wire on skene controller Connect the Cyclops light to the Cyclops power wire harness if you re not using the dimming function the yellow wire on the LED light bar will not be utilized Make sure there ar...

Страница 4: ...an bolts Reinstall your headlight loosely As well as the gas tank This is the time to check your lights function make sure everything works at this time If all is well reinstall all the bikes plastic and seat Aim your LED headlight There are two large Allen bolts one on each end of the light bar after you get your LED light bar aimed where you want it tighten these two bolts failure to do so will ...

Отзывы: