•
Install the included nylon spacers under the Aluminum mount ears.
•
Install the LED Light bar mounting studs in the light bar, then install the light by
tightening the two studs threw the plastic belly pan and aluminum mount, use the
finish washers on the inner side.
•
Fish the power cord threw the ¾ inch hole then install the rubber grommet in the ¾
hole.
Its now time to move on to the wire harness install, If you have ordered the Skene dimmable
option fallow the included Skene/Cyclops instructions.
•
Mount the relay into the back of the factory headlight bucket, use a zip tie to fasten the
relay to the rear of the headlight bucket
See the photo on the next page.