Cyclone Analogic Bass Bot, Руководство по эксплуатации

Страница: 21 / 28

19
The pattern will begin playing upon receiving the Note On message and will stop playing when the Note
Off message is received. For example, to play pattern B- 7 for a single bar you would program a single
MIDI note event for note #26 that is one bar in length. While a pattern is playing, your Bass Bot will use its
LED indicators to show you its Pattern Section and Pattern Number.
The DAW piano roll example image below, shows what a sequence of four patterns would look like when
programmed using this method.
The pattern will be played at the tempo that your Bass Bot receives at its MIDI IN port, so be sure your
DAW or other MIDI clock source is sending MIDI sync clock to your Bass Bot in order to keep it
synchronized. Patterns triggered by these MIDI notes will not play properly if the Bass Bot is not receiving
a MIDI sync clock (in this case only the first note of each pattern will be played).
Tip!
Experiment with sending additional MIDI notes layered on top of a long note used to trigger the
playback of a pattern. You can trigger additional notes or even other patterns that will temporarily override
the pattern that was first triggered.
MIDI Live Performance Mode
You can now add live performance elements to notes and patterns that are triggered by MIDI note
messages that your Bass Bot receives from a DAW or other MIDI controller. With the Mode Switch set to
MIDI Mode, press [PITCH MODE] to enter Live Performance Mode. The Pitch Mode indicator will
illuminate, enabling the use of the DUAS modifiers and the keyboard keys for transposing received MIDI
note and pattern messages. Press [PITCH MODE] again to exit Live Performance mode.
Lesson 17
System Procedures and Operating Guidelines
This lesson covers system functions and general notes on the Bass Bot’s operation and maintenance.
In this lesson, button combinations are written as [FUNCTION] + [NOTE], where “NOTE” is a key on the
musical keyboard portion of the front panel.
System Colors ([FUNCTION] + [F#])
You can customize the system color of your Bass Bot’s LEDs. While in MIDI mode, press [FUNCTION] +
[LED]. You will see the keyboard key LEDs light up in different colors. Simply press the key for the color
you want to use for the system LED color. The factory default system color is red.