Cycle Torch GT 800, Руководство пользователя

Страница: 6 / 8

6
Turning off GT 800: Press and hold the power button for one to three seconds.
A temperature protection circuit will stop the light from overheating, by
stepping the output down if the light is left on full with no airflow around it.
And the brightness will rebound automatically after cooling.
Checking Battery Level: When the light is turned off, press the power button for
3 seconds and release. The light will flash from 1 to 10 times indicating the remaining
battery level (10 flashes indicate - 100% charge, 9 flashes - 90%, 8 flashes – 80% …).
Low Battery Level: The power button light will glow red when the battery level
is low and the light will automatically turn off when the battery level is too low. This
system protects the battery from damage, but since it draws a small amount of
current, and can drain the battery beyond the minimum voltage for the battery.
The light must be turned off when the button glows red or within 5 minutes
of it glowing red. Do not wait until the light goes completely out as this will greatly
reduce the number of charge cycles that the battery can be used and can render
the battery unusable.
Charge your bike light each 2-3 months when stored or not in use to prevent
battery degradation.
Operating modes: High Medium Low Flash
Run time (in hours) 2,5 5 25 50
Power (in lumens) 800 400 80 800
I.
II
.
III
.
IV
.
V
.
VI
.
VII
.