Cycle Torch GT 800, Руководство пользователя

Страница: 5 / 8

5
4. Disconnect the charger when not in use and before connecting or removing
batteries from charger.
5. Do not use charger or battery if, the wires or the batteries or charger have
become damaged.
6. The cable (or other accessories) supplied with the Cycle Torch bike light MUST be
used only to charge the Cycle Torch bike light. The Manufacture or/and the Seller
are not responsible for any damage caused by using the supplied accessories with
other devices, other than Cycle Torch bike lights.
Charging:
1. Plug the battery pack into the charger.
2. Connect the charger to the power outlet.
3. The LED on the charger will glow red when the battery is being charged and turn
to green when the battery is fully charged.
4. When the charger LED turns green, you may unplug the charger and then remove
the battery pack from the charger. Charging a fully depleted battery may take up
to 4 hours.
Tips and tricks:
1. Charge your battery pack immediately after use. Li-ion batteries do not have a
"memory effect" and can be left at full charge, although battery life is extended
if you follow CAUTION step #3 from CAUTION above.
2. Flashing light of the power button shows that a charging error has occurred.
Remove and reinsert the power cable, then begin the recharge process again.
3. The battery charges to about 80% after approximately 3 hours.
4. Charging and lighting times are approximate values, and will vary by
environmental and user conditions.
IV. Switching the lighting modes
Operation Modes: The initial short press of the power button will turn the light on
High mode. Each additional short press of the power button switches the light from one
mode to the next in the following order: (1) High; (2) Medium; (3) Low; (4) Flash
I.
II
.
III
.
IV
.
V
.
VI
.
VII
.