Chapter 6 - Configuration of the SWAN Interface
51
Cyclades-PR4000
STEP FOUR
If PPP Encapsulation is being used, a type of authentication should be chosen. This is done in the authentication
menu.
Authentication Menu CONFIG=>INTERFACE=>SWAN=>AUTHENTICATION
Parameter
Description
Authentication Type
Local uses the list of users defined in CONFIG=> SECURITY=>USERS=>ADD.
Server uses either Radius or Tacacs to authenticate the user.
Remote is when this interface is considered to be the user and the other end of the
connection performs the authentication
Username
Applies when Authentication Type is Remote. The username the remote device
expects to receive.
Password
Applies when Authentication Type is Remote. The password the remote device
expects to receive.
Authentication Server Applies when
Authentication Type is Server. Indicates that either a Radius or Tacacs
server is used for validation. The location and other parameters of the server must be
configured in CONFIG=> SECURITY. See section 4.3 of the CyROS Reference
Guide.
Authentication
Protocol
Applies when Authentication Type is Local or Server. Either PAP or CHAP or both can
be used for authentication.
STEP FIVE
The parameters defined in the Routing Protocol and Traffic Control Menus should be set after reading chapters 9
and 12, respectively. It is probably best to complete the basic configuration of all router interfaces, then return to
the routing protocol and traffic control menus after general routing and traffic control strategies have been defined.
