Cyclades-PR4000
42
Chapter 4 - Step-by-Step Instructions
STEP FIVE
A static route must be added to tell the router that all traffic not intended for the local LAN should be sent to the
Access Provider. Chapter 12 of the Installation Guide explains static routes and other routing methods available
in CyROS. Fill in the spaces in Figure 4.11 with the values for your application.
Menu CONFIG=>STATIC ROUTES=>IP=>ADD ROUTE
Parameter
Example
Your Application
Destination IP
Address
Type in the word "DEFAULT".
Gateway or
Interface
Interface
, because the IP addresses
are not known at configuration time.
Interface
Link 1
in the example.
Is This a Backup
Route?
No
OSPF Advertises
This Static Route
No
FIGURE 4.11 STATIC ROUTE MENU PARAMETERS
STEP SIX
NAT must now be activated. There are two varieties of NAT: Normal and Expanded. This example uses the
Normal NAT Mode. The other mode is explained in the chapter on NAT in the Installation Manual.
Menu CONFIG =>SECURITY =>NAT =>GENERAL
Parameter
Example
Your Application
Nat Status
Enabled
Nat Mode
Normal
Disable Port Translation
No
FIGURE 4.12 GENERAL NAT PARAMETERS
