Cybex Arc Trainer 610A Service Manual
Service
Page 4-19
D.
Using a 9/16” open end wrench and a 9/16” socket wrench, tighten a nut on each bolt.
10. Connect the elevation cable.
A.
Connect the elevation cable to the lower board and place it in the slot mentioned in step 6B.
B.
Place the lower board shield in position and snap it in.
11. Secure the center cover.
A.
Place the center cover in position.
B.
Using a Phillips head screwdriver, attach the two screws removed in step 5A.
12. Secure the side covers.
A.
Place the two side covers and the gasket in position.
B.
Using a Phillips head screwdriver, attach each side cover with the six screws and six washers
removed in step 4A.
NOTE:
You will have to elevate the unit to level 7 to attach the bottom two
screws as discussed in step 1.
13. Attach the connecting rods.
A.
Place each connecting rod in position.
B.
Using a 3/16” Allen wrench, attach each connecting rod with a screw removed in step 3A. See
Figure 4.
14. Attach the access cover.
A.
While being sure not to pinch any cables, place the access cover in position.
B.
Using a Phillips head screwdriver, attach the four screws removed in step 2A. See Figure 2.
15. Test the unit for proper operation.
A.
Connect the power cord into the power outlet.
B.
Turn the main power switch above the power inlet to the on (I) position.
C.
Operate the unit at all levels to verify proper operation.
