Safety Precautions
Move & Install
Danger
Keep the equipment away from heat source or air outlets.
In case of fire, use dry powder extinguisher only, any liquid
extinguisher can result in electric shock.
Warning
Do not start the system if any damage or abnormal parts
founded.
Contacting the UPS with wet material or hands may be
subject to electric shock.
Attention
Use proper facilities to handle and install the UPS. Shielding
shoes, protective clothes and other protective facilities are
necessary to avoid injury.
During positioning, keep the UPS way from shock or
vibration.
Install the UPS in proper environment, more detail in section
3.3.
Debug & Operate
Danger
Make sure the grounding cable is well connected before
connecting the power cables, the grounding cable and
neutral cable must be in accordance with the local and
national codes practice.
Before moving or re-connecting the cables, make sure to
cut off all the input power sources, and wait for at least 10
minutes for internal discharge. Use a multi-meter to
measure the voltage on terminals and ensure the voltage is
lower than 36V before operation.
Attention
The earth leakage current of load will be carried by RCCB or
RCD.
Initial check and inspection should be performed after long
time storing of UPS.
Maintenance & Replacement
Danger
All the equipment maintenance and servicing procedures
involving internal access need special tools and should be
carried out only by trained personnel. The components that
can only be accessed by opening the protective cover with
tools cannot be maintained by user.
This UPS full complies with “IEC62040-1-1-General and
safety requirements for use in operator access area UPS”.
Dangerous voltages are present within the battery box.
However, the risk of contact with these high voltages is
minimized for non-service personnel. Since the component
with dangerous voltage can only be touched by opening the
protective cover with a tool, the possibility of touching high
voltage component is minimized. No risk exists to any
personnel when operating the equipment in the normal
manner, following the recommended operating procedures
