Setting Up the V3 Paging Server
Removable Connector
CyberData Corporation
930427L
Operations Guide
8
2.3.1.1 Pin 1 and 2—Fault Sense Input (Common/Sense)
This input was designed as a method of monitoring an external amplifier that is equipped with a fault
sense relay.
When enabled via the web interface (
Section 2.4.8, "Configure the Fault Detection Parameters"
), this
input (when closed) will play a user uploadable audio file out of the line-out connection and/or place
a SIP call to a pre-determined extension and play that file.
2.3.1.2 Pin 3, 4, and 5—Positive/Negative 600-Ohm Audio Output/Audio Ground
Reference
This output allows direct connection to paging amplifiers requiring a "Page Port" type input that
meets a balanced 600 Ohm 5VPP signal.
2.3.1.3 Pin 6 and 7—Relay Contact (Common/Normally Open)
When enabled on the web interface (
Section 2.4.4, "Configure the Device Parameters"
), every time
an audio file is played out of the local line-out or 600 Ohm output, the relay will close, thereby
enabling amplifiers with a remote turn-on capability to become active.
2.3.2 Removable Connector
Figure 2-4
shows the connector that is removable on the V3 Paging Server.
Figure 2-4. Removable Connector
