Setting Up the V3 Paging Server
Announcing the IP Address
CyberData Corporation
930427L
Operations Guide
12
2.3.6 Announcing the IP Address
To announce the IP address for the V3 Paging Server, briefly press and then quickly release the
RTFM switch. See
Figure 2-8
.
Figure 2-8. RTFM Switch
2.3.7 Restore the Factory Default Settings
The V3 Paging Server is delivered with factory set default values for the parameters in
Table 2-3
. In
addition, the settings for various UI web pages (such as the
Device Configuration Page
,
SIP
Configuration Page
, etc.) are delivered with the factory default settings and can be restored to
these default settings when you use the RTFM switch. However, uploaded audio files are not
restored to the factory default settings when you use the RTFM switch.
Use the RTFM
switch (see
Figure 2-8
) on the back of the unit to restore these parameters to the
factory default settings.
Note
When you perform this procedure, the factory default settings are restored. The default
parameters for access are shown in
Table 2-3
.
To restore these parameters to the factory default settings:
1. Press and hold the RTFM switch until the status and paging lights come on.
2. Continue to press the RTFM switch until after you see the indicator lights go off and you hear the
“restoring defaults” announcement.
3. Release the RTFM switch.
4. The V3 Paging Server settings are restored to the factory defaults.
RTFM Switch
Table 2-3. Factory Default Settings
Parameter
Factory Default Setting
IP Addressing
DHCP
IP Address
a
a. Default if there is not a DHCP server present.
10.10.10.10
Web Access Username
admin
Web Access Password
admin
Subnet Mask
a
255.0.0.0
Default Gateway
a
10.0.0.1
