CAUTION!
Read and follow the IMPORTANT
SAFETY INSTRUCTIONS before servicing
the battery. Service the battery under the
supervision of personnel knowledgeable of
batteries and their precautions.
CAUTION!
When replacing batteries, replace
with the same number of the following
battery: CyberPower/RB0670X2 for
OR500LCDRM1U and CyberPower/ RB0690X2
for OR700LCDRM1U. See your dealer for
replacement batteries.
CAUTION!
Risk of energy hazard, 6V,
maximum 8AH battery. Before replacing
batteries, remove conductive jewelry such as
chains, wrist watches and rings. High energy
thorough conductive
CAUTION!
Risk of explosion if battery is
replaced by an incorrect type. Dispose of used
batteries according to the instructions.
CAUTION!
The battery may present the risk of
electrical shock. Do not dispose of batteries
in a fire, the batteries may explode. Follow all
local ordinances regarding proper disposal of
batteries.
CAUTION!
Do not open or mutilate the
batteries. Released material is harmful to the
skin and eyes and may be toxic.
CAUTION!
A battery can present a high risk of
short circuit current and electrical shock. Take
the following precautions before replacing the
battery:
1. Remove all watches, rings or other
metal objects.
2. Only use tools with insulated handles.
3. DO NOT lay tools or other metal parts on
top of battery or any battery terminals.
4. Wear rubber gloves and boots.
5. Determine if the battery is inadvertently
grounded. If inadvertently grounded,
remove source of ground.
CONTACT WITH A GROUNDED BATTERY
CAN RESULT IN ELECTRICAL SHOCK!
The
likelihood of such shock will be reduced if
such grounds are removed during installation
and maintenance (applicable to a UPS and a
remote battery supply not having a grounded
circuit).
CAUTION - RISK OF EXPLOSION IF BATTERY
IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO LOCAL REGULATIONS
REPLACING THE BATTERY
BATTERY REPLACEMENT PROCEDURE:
1. Remove the right-side of the faceplate.
2. Remove the three retaining screws on the cable protection cover then remove the cover.
3. Disconnect the black and red cable.
4. Remove the retaining screw of the cable connectors.
5. Replace the new battery pack. Assemble the screws, cover, cable and front panel in the
reverse sequence of above steps. Recharge the unit for 8 hours to ensure the UPS performs
expected runtime.
1
2
4
5
3
REMINDER:
Batteries are considered
HAZARDOUS WASTE
and must be disposed
of properly. Most retailers that sell lead-acid
batteries collect used batteries for recycling,
as required by local regulations.
