CVS SKL 1200 C, Руководство по сборке

Страница: 20 / 32

Assembly instructions Screw compressor SKL 1200 C
Installation and assembly
20
6.4 Installation requirements
Attaching the compressor The compressor is mounted on 3 attachment points M16 (see
Fig. 2, pos. 1) either right or left on each side of the
compressor, inside the vehicle frame.
Requirements
on the installation panel and
the fixture

The installation panel and attachment points on the vehicle
must be of adequate load-carrying capacity and stiffness.

The two attachment points lying vertically on top of each
other are in one plane.
The third attachment point is set back by 15 mm or 45 mm
(see Fig. 1 footnote). Suitable spacer elements (see Fig. 5,
pos. 16) must be used for screwing.

The fastening screws must feature a sufficient clamping
length.
Requirements
upon the installation location The installation location must fulfil the following requirements:

Protect from dirt, falling rocks and spray water.

Offer sufficient space for accidental contact protection.

Offer sufficient space for the connections of the suction and
pressure lines.

Ensure good legibility of the instruments.

be accessible for maintenance and repair work e.g. for
replacing the oil filter, or for checking the safety and non-
return valve.
Installation position

The pressure flange must point upwards.

Mount the compressor horizontally or with an inclination (see
table 1) according to the inclination of the auxiliary drive.
Assembly

Install the compressor with screws according to the following
table free from distortion.
Use the following screws to attach the compressor:
Screw Model Solidity Torque
Screw-in depth in the housing
of the compressor
M16 Verbus Ripp 8.8
190 Nm
22…24 mm
Tab. 6: Fastening screws