P.O. Box 749 Peekskill, NY 10566 Tel: (845) 737-7009 Fax: (845) 737-0426 Web: www.compuvideosystems.com
Installing a Board Set in an open slot:
A) Locate the slot that the front board will be installed in. Holding the board so
that the components face left, carefully slide the board into the slot. Seat the
board in the mating connector in the motherboard. If you meet any
resistance, remove the board and check for bent pins and a misaligned
mating connector in the back of the slot. After correcting the error, reinstall
the board. Then reinstall both screws that hold the board in place.
B) On the rear of the unit you need to install the connector field. Carefully align
the top pin on the back of the connector field with the top pin on the internal
connector on the rear of the chassis. There may be open slots on the
connector in the chassis. After the connector panel is installed, using a small
Philips head screwdriver, install the two mounting screws in the panel.
C) Once the boards have been removed/installed you can reconnect the video
cables.
D) Reconnect the AC power and check for an LED on the video switcher
indicator or a video presence indicator. If none is visible, check you power
connections. If a problem persists, gently unplug the main board of the BS
you just installed. If the power returns, check for a misalignment when the
board is installed. If there is a shift from top to bottom you can improperly
install the boards and short the power supply. Reset the board.
E) Attach a test monitor the recently installed BS and test for proper operation.
Check for video. If none is present, check the installation of the rear
connector field for a misalignment. Reset the rear connector panel and test
again. Align the board as specified.
If any problems persist, call
845-737-7009
and ask for tech support.
Fig. 9
Rear View Of DABS-2032
Screws That Need To Be Removed
Before You Slide The Card Out
Содержание DA-3212
Страница 20: ......