CVS DA-3212, Инструкция по эксплуатации

Страница: 7 / 20

P.O. Box 749 Peekskill, NY 10566 Tel: (845) 737-7009 Fax: (845) 737-0426 Web: www.compuvideosystems.com
Installation And Removal Of A Board Set (BS) From
The DA-3212 Chassis.
Boards can be Hot Swapped if needed but it is recommended that power be disconnected
before changing any boards.
1) Remove power from the system by unplugging the power pack(s) from the 110VAC
source.
2)Remove the 2 screws holding the desired board in the chassis
Removal of a BS:
A) Determine which board set is to be removed. Locate the BS and remove the
2 screws holding the board in place (Fig.8). Then unplug the board by gently
pulling the board towards the front of the chassis.
B) On the rear of the unit ( Fig. 9) is a matching connector board that must be
removed if a complete boards set is being changed. As there are no
electronics on the rear board you do not need to change it for repair purposes.
Locate the corresponding rear connector set, mark the connectors. Using a
small Phillips head screwdriver, remove the top and bottom screw from the
connector panel. Carefully, holding on to a connector, pull the panel away
from the rear of the chassis. Put the main board and the connector board
together.
Fig. 8
Removal Of Front Panal
Screws That Need To Be Removed
Before You Slide The Card Out