P.O. Box 749 Peekskill, NY 10566 TEL: (845)737-7009 Fax: (845)737-0426 Web: www.compuvideosystems.com
Each switcher kit should contain each of the following items:
Instruction sheet
Power Pack
Switcher
1)
Connect the power supply to the switcher by pushing the power connector into the rear of the switcher until
it can go no further.
2)
Plug in the power pack to a 115VAC source. Turn on the switcher by rotating the “Scan Rate” Knob to the
right. The speed at which the channels are selected is adjusted by this knob.
3) SCAN;
Place all of the switches in the center position. The LED’s (lights) will sequence at the rate set by
the knob.
4) BYPASS;
By placing the switch up, that position will be skipped when the scan comes to that position.
5) HOME;
Will freeze the scan to the selected position. If more than one position is selected, the higher
number will be activated.
CTS-2: 2x1 Terminating Video only sequential switcher
CTS-4: 4x1 Terminating Video only sequential switcher
CLS-4: 4x1 Looping Video only sequential switcher
CLTS-4: 4x1 Looping with internal terminators Video only sequential switcher
CTS-8: 8x1 Terminating Video only sequential switcher
CLS-8: 8x1 Looping Video only sequential switcher
CLTS-8: 8x1 Looping with internal terminators Video only sequential switcher
SYSTEM CONNECTIONS:
INPUTS
OUTPUT
POWER
CTS-8 Shown
