Notes:
NODE 101 / CUTOK with a "real" USB interface (not USB-serial and parallel),
can achieve plug-and-pull,if pull (or shutdown) it the computer shows as
offline,plug in (or start) the system automatically loads device and appears as
online.
A. Before turn on the plotter,start the computer firstly.
B. In working, to avoid switching on or off frequently the cutting plotter,and a
short interval between switch on and off (plug and pull).
C. After turn on(plug) the plotter, wait 10 seconds, then send the data. You
would better check the equipment is online before using.If offline, shut down
or disconnect USB and start again later to automatically connect. Do not modify
the properties in computer system.
9
