12
CustomControls, LLC
Connecting Controller
Step 1: Depending upon your model, connect Motor to Controller by connecting the red and black wires from the
motor to positive and negative terminals on the Controller.
Step 2: Plug Power Supply into connector
on Controller. Note the Power Supply may
look differently than shown below. Plug in
the Power Supply to a 120 Volt properly
grounded power outlet.
Step 3: Connect wires from water sensor to water sensor terminals on
Controller. The polarity or wires is not important. Multiple sensors can be
connected in polarity.
NOTE: Under rare circumstances the motor needs to
be mounted upside down on the disc shaft to fit the
installation. You can do this as long as you reverse the
connections of the motor wires to the controller by
placing the red wire on the negative terminal and the
black wire on the positive terminal.